TUBE WORKS MOSVALVE 7200-15 BASS COMBO 15" WOOFER 3" TWEETER SUPER LOUD!

TUBE WORKS MOSVALVE 7200-15 BASS COMBO 15" WOOFER 3" TWEETER SUPER LOUD!

Product Code:Guitar-1472304013
Availability:In Stock
  • $568.95

  • Ex Tax: $568.95

TUBE WORKS MOSVALVE 7200-15 BASS COMBO 15" WOOFER 3" TWEETER SUPER LOUD!

Brand: TUBE WORKS
;POWER: 130 WATT / 200 WATT @ 4Ω WITH MOSVALVE POWER
;MPN: 7200-15
;Type: BASS COMBO
;Amplifier Type: BASS COMBO
;Model: MOSVALVE 7200-15
;Impedance (ohms): 8 Ω / 4 Ω WITH MOSVALVE POWER
;Country/Region of Manufacture: United States
;UPC: Does not apply

TUBE WORKS MOSVALVE 7200-15 BASS COMBO 15" WOOFER 3" TWEETER SUPER LOUD!


B.K. BUTLER DESIGN
TUBE WORKS 
7200-15
MOSVALVE 
BASS COMBO
CLEAN AND SUPER LOUD!
BLACK TOLEX COVERING
15" WOOFER
3" HORN
FANTASTIC QUALITY BUILT COMBO





FRONT PANEL FEATURES 
TUBE/F.E.T. SWITCH: Selects either the TUBE or F.E.T. preamp. Generally speaking, TUBE will give a slightly fatter, more colored tone with slightly more distortion and decreased headroom at high volume settings. F. E.T. offers the quietest, most accurate and tightest response. INPUTS: Input 1 is +6db for passive basses and Input 2 is set @ 0db for active basses. NOTE: Inputs are summing, allowing for two instruments of similar outputs to be successfully summed. VOLUME: Controls gain through the input preamp (either TUBE or F.E.T.) LIMITER: Averages input signal levels to increase headroom and help prevent excessive speaker bottoming due to large signal transients. The unique quality of this type of limiter is that it still retains dynamic response even at high (numerical) settings. Limiting will increase as the control is moved towards “10”. The associated red LED will indicate limiter activity on a continuous basis. The Limiter is cancellable via a rear-panel foot switch jack or by setting the control to “0”. CONTOUR: Forms a gentle over-all bass response slope across the most active bass frequencies. This is very useful in compensating for stage size and room acoustics. LO: Controls and shelves frequencies in the extreme low-end of the spectrum of 150 HZ and less. LO MID: Controls frequencies between 100 HZ and 400 HZ. MID: Extremely wide-range control of frequencies between 400 HZ and 1500 HZ. HI: Shelves and controls frequencies of 1500 HZ and higher. NOTE: These EQ controls are interactive. There is mild reaction between the controls including some phase shifting. This results in continuously variable coloration of your tone including aural enhancement. MASTER: Controls input gain to the power amp section. For best signalto-noise ratio set the input volume relatively high and use relatively lower settings of the Master volume. The Limiter is more active with higher input settings as well. EFFECTS MIX: This control mixes the signal at the “Effects In” jack on the rear panel. Rotating the control towards “EFX” mixes more of the effect’s sound, while “Dry” mixes more of the pre-effect signal to the power amp. POWER: Supplies mains power to the amp. Be certain that the proper voltage is supplied to the amp. The rated voltage for your unit is indicated on the rear panel. The green LED is the power indicator. 
REAR PANEL FEATURES 
POWER CORD: Always use a grounded outlet to avoid operating problems and to increase safety margin. FUSE: Use fast-blo 4 amp for 120V US versions or 2 amp for 220-240V versions. Always replace with the same type and size fuse. LINE OUT: Attenuated signal from the output of the amp. All of the tone of the amp, including the output is available at this jack. Potential applications: Slaving to another combo or power amp and recording. This output is isolated from the chassis ground to help prevent ground loops. SPEAKERS: Use these jacks for speaker output only. Minimum total impedance is 4 ohms. Lower impedance operation is not recommended , and may eventually overheat and damage the amp. Note: RMS Power: 130 Watts @ 8 ohms/200 Watts @ 4 ohms. LIMITER CANCEL: This jack provides for a simple shorting-type footswitch operation of the Limiter. EFFECTS LOOP: This system provides ultimate flexibility and control for your effects, regardless of type. Special note for proper use of the effects loop: “SEND” with as much level as you can without distorting the effect. “RECEIVE” with the minimum level possible to reach unity gain with or without the effect activated. PRE EQ/POST LOOP SWITCH: Selects the output mode of the “Preamp Output” balanced connector. Pre EQ setting will send the amplified preamp output-Volume control output- directly to this connector. The F.E.T. or Tube will be included in this setting, but no EQ or effects. “Post EQ” setting will include all front-panel controls include the Effects Loop setting. PRE AMP OUT & DIRECT OUT: True balanced output of the bass signal useful for sending direct -to- board signals through long snakes. The impedance on both outputs is less than 200 ohms and completely balanced

TUBE WORKS MOSVALVE 7200-15 BASS COMBO 15" WOOFER 3" TWEETER SUPER LOUD!

Looking TUBE WORKS MOSVALVE 7200-15 BASS COMBO 15" WOOFER 3" TWEETER SUPER LOUD! to replace your martin hd28 d28 D45 D35 d42 d41 Martin om-42 martin om-28 martin 00028ec martin 00045ec Cibson J200 Gisbon sj200 Cibson j-45 taylor 914ce taylor 918e taylor 916ce taylor k24ce Cibson es335 Cibson SG Gretsch G5420T Gretsch white falcon Squier Deluxe Strat fender stratocaster Fender Telecaster . we make a drop-in replacement for it. If you’re not sure who made the guitar just contact with us .Guitars China competes with the biggest names in the guitar Market.

Reviews (0)

There are no reviews for this product.

Write a review

Note: HTML is not translated!
    Bad           Good

Tags: TUBE WORKS MOSVALVE 7200-15 BASS COMBO 15" WOOFER 3" TWEETER SUPER LOUD!